PDS_VERSION_ID = PDS3
RECORD_TYPE = STREAM
DATA_SET_ID = "RO-C-RPCLAP-2-EXT2-MTP030-V1.0"
PRODUCT_CREATION_TIME = 2006-10-26T11:45:00
PRODUCT_ID = "RPCLAP030101_CALIB_FRQ_D_P2"
^TEXT = "RPCLAP030101_CALIB_FRQ_D_P2.TXT"
OBJECT = TEXT
PUBLICATION_DATE = 2017-08-09
NOTE = "
        This file contains frequency response from sensor/probe 2 to the ADCs. 
        It contains several frequency series each 401 steps long separated by headers. 
        See example header below:
        
        --------------------------------------------------------------------------------
        Thu 03/May/2001 13:37:39
        FRQRES P2 Density 1Mohm RF=1Mohm 8kHz ADC input  Ref harness  Source Amp  -7.000
        Freq.          Amp 1           Pha 1           Amp 2           Pha 2
        --------------------------------------------------------------------------------

        The header is 3 lines and the - is not part of the header. 
        Line1: Creation date
        Line2: Different parameters as follows:
               P2          Probe/Sensor 2
               Density     Density mode, also in file name abbreviated with _D_
               1Mohm       This is the serial source resistance used during measurements.
               RF          This is the feedback resistor on the amplifiers, thus the current gain.
               8 kHz       Analog filteres used
               ADC input   Measurment path probe to ADC input
               Ref harness Means the reference harness was used.
               Source Amp  Gives the amplitude of the frequency source/[dBm]
        Line3: Column descriptions, note Amp 2 and Pha 2 is not used.
               Freq        Source frequency/[Hz]
               Amp1        Amplitude/[dB]
               Pha1        Phase/[Degrees]
        Then there are 401 lines of data, then a new header and new data etc. 
"
END_OBJECT = TEXT
END