PDS_VERSION_ID = PDS3
RECORD_TYPE = STREAM
DATA_SET_ID = "RO-C-RPCLAP-2-EXT2-MTP030-V1.0"
PRODUCT_CREATION_TIME = 2006-10-26T11:45:00
PRODUCT_ID = "RPCLAP030101_CALIB_FRQ_E_P2"
^TEXT = "RPCLAP030101_CALIB_FRQ_E_P2.TXT"
OBJECT = TEXT
PUBLICATION_DATE = 2017-08-09
NOTE = "
This file contains frequency response from sensor/probe 2 to the ADCs. 
        It contains several frequency series each 401 steps long separated by headers. 
        See example header below:
        
        --------------------------------------------------------------------------------------
        Sun 06/May/2001 23:18:22
        FRQRES P2 E--field 100kohm Boot  on  Cbias on  Bias E  4kHz filter  Source Amp  -7.000
        Freq.          Amp 1           Pha 1           Amp 2           Pha 2
        --------------------------------------------------------------------------------------

        The header is 3 lines and the - is not part of the header. 
        Line1: Creation date
        Line2: Different parameters as follows:
               P1          Probe/Sensor 1
               E--field    E-field mode, also in file name abbreviated with _E_
               100Kohm     This is the serial source resistance used during measurements.
               Boot on     Boot strapping is on, can also be off
               Cbias       Current bias on, can also be off
               Bias E      Bias is E-field bias
               4KHz        Analog filter used, can also be 8KHz
               Source Amp  Gives the amplitude of the frequency source/[dBm]
        Line3: Column descriptions, note Amp 2 and Pha 2 is not used.
               Freq        Source frequency/[Hz]
               Amp1        Amplitude/[dB]
               Pha1        Phase/[Degrees]

       Then there are 401 lines of data, then a new header and new data etc. 
"
END_OBJECT = TEXT
END